Quite a few people have asked how do you enable wireless isolation? The solution is simple and is fairly similar for many types of routers that come with wireless isolation for a feature. It really is essential to note that only some routers include wireless isolation, and some of them may reference to it as wireless client isolation or merely client isolation. 192.168.0.254
Currently the initial thing to do is usually to log into your router’s web based control panel. To get into your router’s user interface get into a web browser (Internet Explorer, Mozilla Firefox, Google Chrome, etc) and key in in the internet protocol address of your router within your address box. Example:192.168.1.1 This should deliver you use of your router’s user interface. Most routers will most likely have an ip address printed on them as well as a account information. In case your router doesn’t have this data in the label on the device, look at the documentation that was included with your router. In cases where you can’t run across the settings address contained in the documentation or upon the router try several following: 192.168.0.1, 192.168.1.1, 192.168.0.100 or 192.168.100.1. If you continually cannot acquire connection to your router’s user interface it’s probably a good idea to give the manufacturer a try.
When you finally make connection to your router you could be required to enter a login and password. That will be specifically the login and security password for your own router, not your web provider or computer’s log on, unless of course you previously changed the settings in the router. The user name and security password in many cases are on the label of your router next to the ip address to gain access to the router. Normally the user name is either Admin, Administrator, or Root. The password is commonly either blank, as in you don’t really have to type one in. Or perhaps is the particular name of the maker for the router. If you cannot find this information and not one of the above works chances are you’ll will need to call your router’s manufacturer.
After getting logged in to your router you will see a web site page containing information about your router. Along the top, or even the left side are likely to be tabs. You want to choose the tab which says “Wireless Settings”, “Wireless Access Point” or something equivalent. When you’ve clicked that tab you would like to look underneath the section on “Wireless Access Point”, or “Wireless Security”. It’s usually around the section focussing on the SSID (which refers to Service Set IDentifier). Usually all you need to accomplish to enable wireless isolation is select the check box and after that hit “Save” or “Apply”. If you don’t see “Wireless Isolation”, look for “Wireless Client Isolation”, or “Client Isolation”. The setting might also be underneath a tab labeled “Advanced Wireless Settings” or possibly anything similar. It can also be possible that your router really doesn’t support the ability to perform Wireless Isolation as only a few routers include this feature.